Steps In Putting Speaker Cables Behind The Walls

Home theater systems are becoming increasingly popular today, and most homeowners would like to have a good one. One problem with these systems, as well as the high cost cables. As more devices connect cables in the living room or bedroom, the result is ugly spiral cables. The answer is to fish cables through the wall. It sounds a bit scary, but the only way to get HDMI cables or speakers to go around on the ground and make a mess.

Installing cables in the walls be a difficult task, but can be done with simple tools. Here are some things that need to:

First Drilling
Second Drywall saw
Third Screwdriver
4 Glow Sticks
5 Electrical Tape
Level 6
7 Stud Finder
8 mounting bracket

The integral cable holder on the wall. It is important in two ways. First, dry wall prevents the break. Secondly, it serves as a board that can be installed on the wall.

A wall speaker wire installation depends on the wall. However the Home General Cable installation, follow these steps:

First Get a stud finder and use it to highlight two of the four holes in a convenient location on the wall. Then use the location of the block behind the firewall. Ideally, the wall panels installed on the wall where there is a fire block.

Using the second wall before drywall saw to cut. You must find two rectangular hole in the wall where your cables. Do this carefully to avoid damage to the wall or puncture more than he intended.

If third holes, brackets can now be. On the side of the bracket should sit on the drywall. Once properly installed, you can securely screws into the wall.

4. Use a glow stick to cables, and the location of the holes through the wall. Tape the edge of the cable on the edge of the glow sticks, and then the cable through the wall and the second disc. The cables can then be attached to the, support wall that are placed on the wall. If you encounter a fire block, go to number 5

5. To connect the cable through the fire block, the block set fire using pin finder and a reduction of the fine square hole. Then drill a hole through the fire, just big enough for cables to pass through. To close the gap on the heat block with an approved sealant. According to a piece of drywall before you cut, and then patching. Finally, the cables will be directed on the second drive as described in step 4

Please note that your country specific fire prevention regulations. Ask your local fire department before you do anything to stop the fire.

If these steps are far beyond your ability, ask for professional support service.